價格：免費
更新日期：2018-07-25
檔案大小：因裝置而異
目前版本：因裝置而異
版本需求：Android 因裝置而異
官方網站：https://skyglyph.com/
Email：office@skyglyph.com
聯絡地址：36 Vitosha Blvd., apt. 8 Sofia 1000 – Bulgaria
Automated collecting of "photos for orthomosaic" with DJI drones.
General process:
1. Remove DJI GO and other apps working via cable with your drone from default apps (settings\apps\default apps\default app selection\DJI Go\Clear defaults)
2. Check your drone, battery and remote controller;
3. Connect your phone with AeroScouter installed to the Remote controller by standard cable (same as you are using for DJI GO);
4. Turn on the remote controller and allow using of USB connection for AeroScouter;
5. Turn on the drone and wait for the message "Drone is connected";
6. Select your mission, check the border (edit or draw the border if it is needed);
7. Check flight parameters (altitude, speed, direction) and home point;
8. Press Takeoff button and wait for landing (control position and flight parameters of the drone);
9. Upload photoset into your mission in Skyglyph Cloud after landing for further processing.
Currently the application tested with:
- Mavic Pro,
- Phantom 4 Advanced,
- Matrice 100.
But it should also work with drones listed below.
Please contact Skyglyph Support Team before using with these drones:
- Phantom 4
- Inspire 1
- Inspire 2
- Matrice 200
- Matrice 210
- Matrice 210
- Matrice 600
- Matrice 600 Pro
! Your android device should be connected to the remote controller via the USB cable !
! DJI GO and other apps working via cable with your drone should be removed from Default Apps !
